Make a Kaye Walker All Terrain and for Beach

Post Reply
Posts: 1
Joined: Thu Sep 05, 2019 7:58 pm

Thu Sep 05, 2019 8:08 pm

Honestly we haven’t taken it to the beach yet, but I think it will be fine in the sand. The wheels are for a beach wagon.

Total cost was right about $150. It didn’t take long to build if you are comfortable with a drill, and basic hand tools.

I ordered stainless steel tubes (I got 18”, could have used 16”, maybe different for different sized walkers) ... ealed.aspx

These are the wheels I ordered: ... UTF8&psc=1

These are the spring clips I ordered:

I was able to get 6” hex head bolts, washers, lock washers, and nuts (3/8” hardware) at Home Depot

The wheels are through a 3/8” hole about an inch from the bottom, and a 3/8” hole about 1/2” from the top for the spring clip. The holes were drilled with a smaller drill bit, then re-drilled with a 3/8” bit.

There is a little bit of trial and error to tighten the nuts on the tube and not squeeze the wheel.
69628802_2358197294294661_3195398845806673920_n.jpg (216.68 KiB) Viewed 47018 times
69699607_519043022191900_6401347226508984320_n.jpg (204.3 KiB) Viewed 47018 times
69704544_2347501668837756_1802485520865951744_n.jpg (217.62 KiB) Viewed 47018 times
Post Reply