Honestly we haven’t taken it to the beach yet, but I think it will be fine in the sand. The wheels are for a beach wagon.
Total cost was right about $150. It didn’t take long to build if you are comfortable with a drill, and basic hand tools.
I ordered stainless steel tubes (I got 18”, could have used 16”, maybe different for different sized walkers)
https://www.speedymetals.com/pc-4479-82 ... ealed.aspx
These are the wheels I ordered:
https://www.amazon.com/gp/aw/d/B07NXY3Z ... UTF8&psc=1
These are the spring clips I ordered:
I was able to get 6” hex head bolts, washers, lock washers, and nuts (3/8” hardware) at Home Depot
The wheels are through a 3/8” hole about an inch from the bottom, and a 3/8” hole about 1/2” from the top for the spring clip. The holes were drilled with a smaller drill bit, then re-drilled with a 3/8” bit.
There is a little bit of trial and error to tighten the nuts on the tube and not squeeze the wheel.
1 post • Page 1 of 1
- 69628802_2358197294294661_3195398845806673920_n.jpg (216.68 KiB) Viewed 7283 times
- 69699607_519043022191900_6401347226508984320_n.jpg (204.3 KiB) Viewed 7283 times
- 69704544_2347501668837756_1802485520865951744_n.jpg (217.62 KiB) Viewed 7283 times